160º square PIR wall-mounted motion sensor

Infrared motion sensor switch

The motion sensor is the perfect element for the correct energy management of lighting installations. It works in installations with 3 wires. Infrared sensor ideal for replacing recessed switches and automating LED lights in those areas where movements are reduced but it is necessary to keep the light on, such as in offices, school classrooms, bathrooms, corridors, stairways, etc.

Mini sensor for indoor use only with IP20 degree of protection. Automatically identifies day and night. Easy to install and widely used. Integrated button that allows a manual change at any time. Infrared sensor with 160º detection up to 8 meters, for devices or accumulation of loads up to 500W. In 200W LED lights.

Main functions of the motion sensor

Motion sensors activate the switch when motion is detected within the selected detection zone and ambient light levels fall below the threshold selected with the LUX function. After the time has elapsed, the switch is deactivated and the lights are switched off.

➢ Can identify day and night: The consumer can adjust the ambient working light. It can work in the day and night when set to the "sun" (maximum) position. Can work in the Can work in the ambient light less than 10LUX when set in the "-" (min) position. As for the As for the setting pattern, please refer to the test pattern.

➢ Time setting: it can be adjusted according to the consumer's desire. The minimum time is 10sec±3sec. The maximum is 7min±2min.

➢ The switch: from left to right is "OFF"、"PIR". "ON"、

Installation of surface presence sensor.

Installation is very simple:

➢ Disconnect the power supply.

➢ Loosen the connection at the bottom of the sensor, plug the cable into the connection hole, tighten the screws; remove the sensor surface, plug the sensor into the junction box.

➢ If you want to install it in a junction box insert the fixing screw into the installation hole.

➢ Connect the power supply and test it.

Technical characteristics of the presence sensor

• Power supply: 220-240V-AC
• Frequency: 50Hz
• Ambient light: from 3-2000 LUX (adjustable)
• Actuation time: minimum 10 seconds+/-3 seconds.
• Maximum load: 500W. For LED 200W
• Detection distance: maximum 8 meters.
• Detection range: 160º.
• Operating temperature: from -20ºC to +40ºC with relative humidity lower than 93%.
• Recommended installation height: from 2.2 meters to 4 meters.
• Motion detection speed: 0.6 to 1.5 meters/second.

Connection diagram